Skip to content

What is EZPL?

EZPL is the native command language of GoDEX label printers, including the G500 and DT desktop series and the EZ-2000 and ZX1200 industrial lines. Many GoDEX printers can also emulate EPL (GEPL) and ZPL (GZPL), so check which language your printer runs before you convert a job.

^Q50,3
^W60
^H10
^L
AD,40,40,1,1,0,0,LabelZoom
BQ,40,100,2,5,80,0,1,12345678
Lo,40,220,440,224
E
Command What it does
^Q50,3 Sets the label length and the gap after it, in millimeters
^W60 Sets the label width, in millimeters
^H10 Sets the print darkness
^L Starts the label
AD Prints text in internal font D at x, y, with magnification and rotation
BQ Draws a Code 128 barcode
Lo Draws a filled box between two corners, used for lines
E Ends the label and prints it

Setup lengths are millimeters, and every position inside the label is in dots.

Aspect EZPL EPL ZPL
Printers GoDEX Eltron and older Zebra Zebra, and printers that emulate ZPL
Label frame ^L … E N … P ^XA … ^XZ
Lines Lo,x,y,x1,y1: a box between two corners LO: a position, width, and height ^GB
P and R PDF417 barcode and rectangle Print, and reference point Not used

EZPL and EPL look alike, but the same letters mean different things, so an EZPL job sent as EPL doesn’t convert.

These free tools run in your browser:

The LabelZoom API converts EZPL to ZPL, PDF, and images. For example, POST /api/v2/convert/ezpl/to/pdf renders EZPL as a PDF. EZPL is a source format only. Set dpi to the density of the printer the job was written for: a job doesn’t state its density, and a 300 dpi job read at 203 dpi comes out too large and gets clipped.